* Up to 16 outputs * Voltages up to 48V, Current up to 300A * Fast-on output connection * Worldwide approvals & CB report * Medical Approval Option * 3 Year Warranty Key Market Segments & Applications Instrumentation Broadcast Medical ATE Automation Industrial Computing Security Lifesciences/Laboratory Network Servers and Routers Alpha Series 400, 600, 1000 and 1500W AC/DC Modular Features and Benefits Features Benefits * Low Profile * Fast-on output terminal * Medical Approval available * Simpler to install in system * Reduces installation time/errors * Suitable in medical applications INPUT Alpha 400 90 - 264Vac Alpha 600 90 - 264Vac, 160 - 358Vdc Alpha 1000 85 - 264Vac, 120 - 360Vdc Alpha 1500 85 - 264Vac (1000W below 150Vac input) 47 - 63Hz (440Hz with reduced PFC - consult factory) <50A at 25C and 264Vac (cold start) 250Vac HBC Fast Acting (not user accessible) 10A for 400W 12A for 600W 20A for 1000W and 1500W 1.1mA max at 264Vac & 63Hz see configuring guide 0.99 typical Input Voltage Input Frequency Inrush Current Input Fuse Leakage Current Lower Leakage Option Power Factor OUTPUT Voltage / Current Turn on Delay Rise Time Turn on Overshoot Efficiency See module output table 1.5s max <50ms at 90Vac (150Vac for Alpha 1500W) & 100% rated output power to 90% of voltage, monotonic rise above 10% <5% or 250mV Load type dependant, no overshoot with resistive load Ripple & Noise <2% typical at 230Vac & 100% rated power, config dependent at 90Vac & 100% rated output power 13ms for 1000W, 8ms for 1500W and at 207Vac for 1500W (or 100mV if greater) Pk- Pk, using EIAJ test method & 20MHz bandwidth Voltage Accuracy <1% of set Voltage Hold up Remote Sense Minimum Load Temperature Coefficient Load Regulation 75% 15ms min Yes No <0.02% Standard on single output modules on any output of rated voltage per C <0.5% or 25mV for 0-100% load change (with sense connected, <2% without) Line Regulation <0.5% for 90 - 264Vac input change (210-264Vac for 1500W) Cross Regulation <0.2% for 100% load change on any other output <10% of set voltage for 50% load change (above 25% load) Transient Response Recovery Over Voltage Protection Over Current Protection 500s Standard Standard Short Circuit Protection <150% Over Temperature Protection Yes for recovery to 1% or 100mV of set voltage (1000s for S module) for all outputs for all outputs of rated current, when output voltage <1% Shuts down all outputs. Cycle ac off / on to reset Note shutdown temp varies according to ambient, output power and input V Alpha Series 1 SAFETY APPROVALS Date EN 60950-1 2001 UL 60950-1 CSA22.2 No 60950-1 IEC60950-1* Amendments Date IEC 60601-1a 1988 2003 UL 60601-1a 2003 2003 CSA 60601-1a 2003 2001 CE Mark * CB Certificate and report available on request Amendments A1, A2 LV Directive 2006/95/EC (EN60950-1) a - Only for LL, RL and TL leakage variants. CA400 + CA1000 only PRODUCT, GENERIC & COLLATERAL STANDARDS Low Voltage Power Supply, EMC EN61204-3: 2001 Medical Electrical Equipment, EMC EN61601-1-2: 2001 Immunity for residential, commercial and light EN61000-6-1: 2001 industrial environments Immunity for industrial environments EN61000-6-2: 2001 Emissions for residential, commercial and EN61000-6-3: 2001 light industrial environments Emissions for industrial environments EN61000-6-4: 2001 Compliant to High Severity Immunity Compliant Class A emissions for CA1000 / CA1500 Class A emissions for CA1000 / CA1500 Compliant Compliant Compliant CA1000 and CA1500 not compliant Compliant EMISSIONS Radiated Electric Field EN55022 Conducted Emissions EN55022 Class B (as per CISPR.22) See application note for details. Class A for Alpha 1000/1500 Only for `S' type leakage versions Class B (as per CISPR.22) Only for `S' type leakage versions. `M' & `L' types meet Class A Class A for Alpha 1000/1500 Conducted Harmonics EN61000-3-2: 2001 Compliant to Class A Flicker EN61000-3-3: 1995 + A1:2001 Compliant - dmax only. Criteria IMMUNITY Air discharge Contact discharge 15kV 8kV Electrostatic Discharge EN61000-4-2 Level 4 Electromagnetic Field EN61000-4-3 Level 3 Fast / Burst Transient EN61000-4-4 Level 4 Surge Immunity EN61000-4-5 Level 3 Conducted RF Immunity EN61000-4-6 Level 3 10V (tested to 12V) A Power Frequency Magnetic Field EN61000-4-8 Level 4 30A Continuous A A Voltage Dips, Variation, Interruptions EN61000-4-11 Class 3 Voltage Fluctuations Class 3 ENVIRONMENT Temperature EN61000-4-14 10V/m (tested to 12V/m) Input 4kV Outputs 2kV, Tested at 5kHz and 100kHz Line to Line (Differential) 1.1kV Line to Earth (Common Mode) 2.2kV For 100 to 240V nominal A A A 0C to 70C operational, -40 to 85C storage (max 12 months) 50C to 70C derate each output by 2.5% per C Low Temperature Start-up -20C Humidity 5-95% RH non condensing Shock 3000 shocks, each of 10g (16ms) half sine Vibration 10 - 200Hz @ 1.5g Altitude 3,000 metres operational (15,000 metres non operational) Pollution Degree 2, Material group 3 IP Rating IP 10 2 A B for 5s interruptions Derating ISOLATION Input to Output Input to Earth A Reinforced Basic 4.3 kV (dc) 2.3 kV (dc) Output to Earth Output to Output Alpha Series Operational Operational 500 V (dc) 500 V (dc) OUTPUT VOLTAGES (single output modules) Adjustment Amps Slots Module Range (Volts) Module V1 Adjustment Range (Volts) (twin output modules) V2 Adjustment Amps Range (Volts) Amps Slots A 4.5 - 5.5 60 2 E 5 - 16 8 5 - 16 8 1 AA 4.5 - 6.5 60 2 EB 4.5 - 5.5 9 4.5 - 5.5 9 1 1 B 4.5 - 5.5 25 1 EQ 4.5 - 5.5 9 2.7 - 3.9 9 BB 4.5 - 6.5 25 1 H 18 - 32 5 18 - 32 5 1 C 5 - 16 16a 1 P 18 - 29 5 5 - 16 8 1 D 18 - 29 8 1 F 9 - 16 33 2 G 17.5 - 29 25b 2 J 30 - 48 10c 2 K 18 - 29 15 2 L 1.8 - 3.2 25 1 M 5 - 16 8 1 N 18 - 32 5d 1 Q 2.7 - 3.9 25 1 R 2.7 - 3.9 60 2 S 2.5 - 5.7 85 2 T 1.8 - 3.2 60 2 U 10 - 21 16 1 W 4.5 - 5.5 15 1 Z 4.5 - 5.5 25 1 a) b) c) d) 12A max above 12V 21A max above 24.5V Derate output current by 0.25A / V above 40V 1A max above 29V Alpha Configuring Guide The extensive range of output modules and options make it possible to achieve many combinations of Volts and Amps. To achieve the optimum configuration, please contact our sales office. However you can also create your own configuration from this datasheet by using the guide below. Configuring from Datasheet 1 Calculate total output power to determine Alpha 400W, 600W, 1000W or 1500W and select converter, then select required Cooling and Leakage Current from the following table:- CA Output Power Cooling 400 400 600 1000 1500 (5 slots) (5 slots) (7 slots) (8 slots) empty QFa RAb Forward air - Standard Forward air - Quiet fan Reverse air QF LL Earth Leakage Current (at 264Vac, 63Hz) empty ML LL RL TL Standard 1.1 mA 500A 240A 110A 50A Notes: a) CA400/600 only. CA400 derates to 300W, CA600 derates to 475W b) Contact sales office for details 2 Select Output Modules and Options from the Output Voltages tables. Example - if you require 5.2V / 18A with output inhibit : a) select B as closest match for voltage and current and prefix with voltage (e.g. 5.2B) b) add suffix for option (if required) `_PA' for parallel/current share (for N+1 redundant applications) `_PP' for parallel (increase current from one PSU) `_IN' for inhibit `_RP' for remote programming `_MF' (only applicable on 1st module) for global inhibit, ac fail and 5V/50mA standby supply c) repeat for other outputs Ensure that the total width of all selected modules is within the slots for the chosen converter. For example:CA600LL 5A 12/12E 24D which represents a four output 600W Alpha with Forward air, 240A Earth Leakage, with:Output 1 = 5V / 60A with remote sense Output 2 = 12V / 8A Output 3 = 12V / 8A Output 4 = 24V / 8A with remote sense 3 Contact TDK-Lambda to validate configuration and issue a part number. Alpha Series 3 Option Connections 4 1 5 2 6 3 IN, PA, PP, RP Option 1 slot, 2 output 1 slot, 1 output 2 slot, 1 output + + - - + Pin IN option PA option PP option RP option MF option 1 n/c + Sense + Sense + Sense Inhibit (low) 2 Module Good Module Good n/c - Sense 5V supply 3 Inhibit Star point n/c Control 2 Power Fail 4 n/c - Sense - Sense n/c 0V 5 - Power - Power n/c Control 1 Inhibit (high) 6 - Power Star point n/c n/c n/c Alpha 400 Alpha 600 4 Alpha Series + - + - + - Remote sense MF option - 6 5 4 3 2 1 Alpha 1000 Alpha 1500 Alpha Series 5 %%%# ! # & *+7 +1').+7 42+8>1+.'8+1 /3-71+= :+39+ 1,6')42(+ +7 #1/7 6'3)+ +:43 % ! #3/8+* /3-*42 "+1 "+1 '< ,6'3)+,68*01'2(*')42 '< 54;+674198/437908*01'2(*')42 ;;;908*01'2(*')42 ;;;,68*01'2(*')42 8'1= !'1+7 ,,/)+ # $/' *+/ ':46'846/ /3/7+114 '17'24 8'1= /((98> /:'8 '7.147.' 76'+1 "+1 '< /3,4/8'1/'/88*01'2(*')42 "+1 '< /3,43+2/))4/1 ;;;/88*01'2(*')42 ;;;3+2/))4/1 !& '6141*!86'77+ ).+63 +62'3= "+1 '< /3,4-+62'3=*+8*01'2(*')42 ;;;*+8*01'2(*')42 $"" "+).3/)'1 !955468 !8 +8+67(96"+1 !'1+7 47)4; "+1 /3,48*01'2(*'69 ;;;8*01'2(*'69 9786/' !'1+7 ,,/)+ 6+*786'77+ +4(+67*46, 9786/' "+1 '< /3,4-+62'3=*+8*01'2(*')42 ;;;*+8*01'2(*')42 Document number 69698 - Rev 4.3 - Jan 11 6 Alpha Series Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: TDK-Lambda: CA400 H40400